Sunroof Window Height and Opening Fit Adjustment
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Open the front sunroof window to the vent position.
- Loosen the front sunroof window rear screws (1), left and right side.
- Open the front sunroof to the half open position.
- Loosen the front and middle sunroof window screws (1), left and right side.
- Close the front sunroof.
- NOTE:
Tighten the sunroof window in the upper position.
Adjust the window to the following specs, gap 11.0 + or - 0.3 mm (0.43 in) between the front rear and rear front edges.
- Tighten the front sunroof window rear screws (1) to 1.5 N.m (13 lb in).
- Open the front sunroof window until the rear part is in the vent position.
- Tighten the front and middle sunroof window screws (1) to 1.5 N.m (13 lb in).
- Close the front sunroof.
CAUTION:
Refer to Fastener Caution .