Conditions for Running the DTC

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

P0137

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The Ignition voltage is between 10 - 32 V.
The fuel system is operating in Closed Loop.
Device controls are not active.
The fuel level is greater than 10 %.
Ethanol content is less than 87 %.
Decel fuel cut-off is not active.
The DTCs run continuously when the above conditions are met for 5 s.

P0138

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The Ignition voltage is between 10 - 32 V.
Ignition is OFF for greater than 8 h.
The fuel system is operating in Closed Loop.
Ethanol content is less than 87 %.
The fuel level is greater than 10 %.
The engine run time is greater than 30 s.
The engine is not in Power Enrichment.
The DTCs run continuously after an initial delay of 3 min when the above conditions are met for 5 s.

P013A or P013E

Before the ECM can report DTC P013A, or P013C failed, DTCs P013E, P014A, P2270, and P2272 must run and pass.
Before the ECM can report DTC P013E, or P014A failed, DTCs P2270 and P2272 must run and pass.
DTCs P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201 - P0208, P0220, P0222, P0223, P0300 - P0308, P0442, P0443, P0446, P0449, P0455, P0496, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271 are not set.
The Ignition voltage is between 10 - 32 V.
The engine is OFF for greater 8 h.
The learned heater resistance is valid.
The fuel level is greater than 10%.
After the above conditions are met decel fuel cut-off continues without driver initiated pedal input.
The DTCs run once per ignition cycle, during decel fuel cut-off (DFCO), when the above conditions are met.

P013B or P013F

Before the ECM can report DTC P013B, or P013D failed, DTCs P013A, P013C, P013E, P013F, P014A, P014B, P2270, P2271, P2272, and P2273 must run and pass.
Before the ECM can report DTC P013F, or P014B failed, DTCs P013A, P013C, P013E, P014A, P2270, P2271, P2272, and P2273 must run and pass.
DTCs P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201 - P0208, P0220, P0222, P0223, P0300 - P0308, P0442, P0443, P0446, P0449, P0455, P0496, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271 are not set.
The Ignition voltage is between 10 - 32 V.
The engine is OFF for greater 8 h.
The learned heater resistance is valid.
The fuel level is greater than 10%.
After the above conditions are met, fuel enrich mode is continued.
The DTCs run once per ignition cycle when the above conditions are met.

P2270

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013A, P013B, P013E, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271 are not set.
The system voltage is between 10 - 32 V.
The engine is OFF for greater 8 h.
The fuel level is greater than 10%.
The pedal position is less than 4%.
The engine speed is between 950 - 2, 950 RPM.
The engine airflow is between 3 - 12 g/s.
The vehicle speed is between 66 - 124 km/h (41 - 77 mph).
The fuel state is in Closed Loop.
The evaporative emission (EVAP) diagnostics are not in control of purge.
The HO2S heaters are ON for more than 80 s.
The predicted catalytic converter temperature is between 500 - 850°C (932 - 1, 562°F).
This DTC runs once per trip when all of the above conditions have been met for 1 s.

P2271

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P013A, P013B, P013E, P013F, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0411, P0412, P0418, P1174, P1516, P2101, P2119, P2135, P2176, P2270 are not set.
The system voltage is between 10 - 32 V.
The engine is OFF for greater 8 h.
The fuel level is greater than 10%.
The fueling state is in Closed Loop.
DTCs P013A, P013E, and P2270 have run and passed.
THEN
Decel fuel cut-off is active.
The accelerator pedal position is stable.
This DTC runs once per trip when the above conditions are met for 3 s.