Component Testing
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition/Vehicle - Off
- Disconnect the electrical connector:B34 Engine Coolant Temperature Sensor
- Test the resistance between the test points:Signal circuit terminal 2 & Low Reference circuit terminal 1
- Verify the value is within the range listed in the table:Temperature Versus Resistance - Engine Coolant Temperature Sensor
- If not in the specified range
Replace the component:B34 Engine Coolant Temperature Sensor
- Go to next step: If in the specified range
- If not in the specified range
- Test for infinite resistance between the test points:Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component:B34 Engine Coolant Temperature Sensor
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.