Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the condition does not exist:Incorrect fluid level or condition - Refer to:Loss of Coolant
, & Cooling System Draining and Filling (GE-47716)
, or Cooling System Draining and Filling (Static)
- If a condition exists
Repair or replace as necessary.
- Go to next step: If no condition exists
- If a condition exists
- Verify there are no DTCs set related to the following system/component:
- B34 Engine Coolant Temperature Sensor
- { If equipped } B203 Radiator Coolant Temperature Sensor
- { If equipped } Q74 Engine Coolant Bypass Valve
- If a related DTC is set
- Go to next step: If a related DTC is not set
- Engine - Running @ 1, 800 to 2, 200 RPM
Verify the scan tool parameter:ECT Sensor = Greater than 80°C (176°F) - Within 15 min
- If 80°C (176°F) or colder
Test or replace the component: Engine Coolant Thermostat
- Go to next step: If warmer than 80°C (176°F)
- If 80°C (176°F) or colder
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.