Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC P00F4, P00F5, P00F6, P0102, P0103, P0641, P0651, P0697, P06A3, P06D2 is not set.
- If any of the DTCs are set
- Go to next step: If none of the DTCs are set
- Engine - Running
- Verify the scan tool parameter:Intake Air Humidity Sensor = 5 to 90%
- If not between 5 and 90%
Refer to: Circuit/System Testing
- Go to next step: If between 5 and 90%
- If not between 5 and 90%
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.