Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Verify there are no DTCs set related to the following system/component:
- B23 Camshaft Position Sensor
- B34 Engine Coolant Temperature Sensor
- B52 Heated Oxygen Sensor
- B74 Manifold Absolute Pressure Sensor
- B75C Multifunction Intake Air Sensor
- B150 Fuel Tank Pressure Sensor
- Q12 Evaporative Emission Purge Solenoid Valve
- Q17 Fuel Injector
- Q38 Throttle Body
- Engine Misfire
- Fuel Trim System
- If a related DTC is set
- Go to next step: If a related DTC is not set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify DTC P219A, P219B is not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If no DTC is set
- If the DTC sets
- All OK.