Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Verify no other DTCs are set.
- If other DTCs are set
- Go to next step: If no other DTCs are set
- Ignition/Vehicle - Cycle On and Off
Verify the component produces a clicking sound:KR75 Engine Controls Ignition Relay
- If the component does not produce a sound
Refer to: Circuit/System Testing
- Go to next step: If the component produces a sound
- If the component does not produce a sound
- Verify the following parameters are within 3 V of each other:
- Ignition 1 Signal
- Engine Controls Ignition Relay Feedback Signal
- If not within 3 V of each other
Refer to: Circuit/System Testing
- Go to next step: If within 3 V of each other
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.