LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Engine Controls And Fuel - 2.0L (LTG) - DTC P0340-DTC P31BF And Symptoms) >> Diagnostic Information and Procedures >> DTC P0627-P0629 or P12A6 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle & All vehicle systems - Off
  2. Disconnect the electrical connector:K111 Fuel Pump Driver Control Module
  3. Ignition - On / Vehicle - In Service Mode
  4. Perform the scan tool control function:Fuel Pump Enable - Off

    Verify a test lamp does not turn On between the test points:Control circuit terminal 18 X1 & Ground

    • If the test lamp turns On 
    1. Ignition/Vehicle - Off & Remove - Test lamp
    2. Disconnect the electrical connector: K20 Engine Control Module
    3. Ignition - On / Vehicle - In Service Mode
    4. Test for less than 1 V between the test points:Control circuit terminal 18 X1 @ Component harness & Ground
      • If 1 V or greater - Repair the short to voltage on the circuit.
      • If less than 1 V - Replace the component:K20 Engine Control Module
    • Go to next step: If the test lamp does not turn On 
  5. Remove - Test Lamp
  6. Perform the scan tool control function:Fuel Pump Enable - On

    Verify the scan tool parameter:Fuel Pump Enable Circuit Low Voltage Test Status = OK

    • If not the specified state 
    1. Ignition/Vehicle - Off
    2. Disconnect the electrical connector: K20 Engine Control Module
    3. Test for infinite resistance between the test points:Control circuit terminal 18 X1 @ Component harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • If infinite resistance - Replace the component:K20 Engine Control Module
    • Go to next step: If the specified state 
  7. Connect a 3 A fused jumper wire between the test points:Control circuit terminal 18 X1 & Ground
  8. Perform the scan tool control function:Fuel Pump Enable - On

    Verify the scan tool parameter:Fuel Pump Enable Circuit Low Voltage Test Status = Malfunction

    • If not the specified state 
    1. Ignition/Vehicle - Off & Remove - Jumper wire(s)
    2. Disconnect the electrical connector:K20 Engine Control Module
    3. Test for less than 2 ohms between the test points:Control circuit terminal 18 X1 @ Component harness & Terminal 37 X1 @ Control module harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Replace the component:K20 Engine Control Module
    • Go to next step: If the specified state 
  9. Test or replace the component:K111 Fuel Pump Driver Control Module
scientia non olet · About LEMON Manuals