LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Automatic Transmission - VT40 (MRG) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Transmission Fluid Cooler Pipe Fitting Seal Installation

Transmission Fluid Cooler Pipe Fitting Seal Installation

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
GM5021972Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Transmission Fluid Cooler Pipe Fitting Seal [2x]
Procedure
  1. Use DT-47770  Cooler Line Seal Installer to install the transmission fluid cooler pipe fitting seal. Install seal flush or up to 0.3mm (a) below flush.
  2. Install a NEW seal. Do NOT reuse the old seal.

Special Tools 
DT-47770  Cooler Line Seal Installer
Equivalent regional tools:Special Tools
scientia non olet · About LEMON Manuals