Holding Fixture Removal

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Transmission Case WARNING: Handle with care, the transmission assembly weighs over 90.7 kg (200 lbs). Bodily injury could occur if not handled properly. Procedure NOTE: Only 2 bolt holes on the lift plate will align with the bosses on the transmission case. This is sufficient for lifting the transmission to remove the holding fixture. Remove lock pin from DT-3289-20 Holding Fixture. Raise the transmission with an overhead hoist in order to remove the holding DT-46625 Transmission Holding Fixture. Lower the transmission assembly onto the transmission jack in order to remove the DT-46625 Transmission Holding Fixture. Special Tools DT-3289-20 Holding Fixture DT-46625 Transmission Holding Fixture DT-46625-30 Transmission Holding Fixture Adapter Equivalent regional tools:Special Tools

Callout

Component Name

Transmission Case

WARNING:

Handle with care, the transmission assembly weighs over 90.7 kg (200 lbs). Bodily injury could occur if not handled properly.

Procedure

NOTE:

Only 2 bolt holes on the lift plate will align with the bosses on the transmission case. This is sufficient for lifting the transmission to remove the holding fixture.

Remove lock pin from DT-3289-20 Holding Fixture.
Raise the transmission with an overhead hoist in order to remove the holding DT-46625 Transmission Holding Fixture.
Lower the transmission assembly onto the transmission jack in order to remove the DT-46625 Transmission Holding Fixture.

Special Tools

DT-3289-20 Holding Fixture
DT-46625 Transmission Holding Fixture
DT-46625-30 Transmission Holding Fixture Adapter

Equivalent regional tools:Special Tools