LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Automatic Transmission - VT40 (MRG) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Removal

Control Valve Body Assembly Removal

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
GM4650455Courtesy of GENERAL MOTORS COMPANY
Automatic Transmission Wiring Harness Removal

Callout Component Name
1 Wiring Harness Connector Bolt M5 x 20
2 Wiring Harness Connector Bolt [2x] M5 x 25
3 Automatic Transmission Wiring Harness
Procedure
  1. Disconnect the harness connectors.
  2. Slide connector lock as indicated by lower arrow to unlock.
  3. Using a pick or suitable tool press in as indicated by upper arrow and pull connector out.
  4. Remove the wiring harness.
4 Automatic Transmission Fluid Temperature Sensor Seal
Procedure 
Remove and DISCARD the seal.
GM4738268Courtesy of GENERAL MOTORS COMPANY
Control Valve Solenoid Body Removal

Callout Component Name
1 Valve Body Bolt [2x] M5 x 98.3
2 Valve Body Bolt [11x] M5 x 85
3 Valve Body Bolt [7x] M5 x 100
4 Valve Body Bolt [7x] M5 x 70
5 Automatic Transmission Fluid Pressure Sensor [2x]
6 Automatic Transmission Fluid Pressure Sensor Seal [2x]
NOTE:

The seal is reusable, inspect the seal and replace if damaged.
7 Control Valve Solenoid Body
GM4738283Courtesy of GENERAL MOTORS COMPANY
Control Valve Body Removal

Callout Component Name
1 Valve Body Bolt [2x] M5 x 55
2 Control Valve Body
3 Control Valve Body Locating Pin [2x]
scientia non olet · About LEMON Manuals