Circuit/System Description
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
For an overview of the component/system, refer to:Pedestrian Alert Description and Operation
| Circuit | Description |
|---|---|
| B+ - K132 Pedestrian Alert Sound Control Module | Supplied from a fuse. |
| Ground - K132 Pedestrian Alert Sound Control Module | Chassis Ground |
| Pedestrian Friendly Alert Speaker Control (-) | The output circuit is switched to 6 V to activate the component. |
| Pedestrian Friendly Alert Speaker Control (+) | The output circuit is switched to 6 V to activate the component. |
| Component | Description |
|---|---|
| P48 Pedestrian Alert Sound Speaker | Each of the speaker output [+] and [-] circuits has a DC bias voltage that is approximately one half of the battery voltage. When using a DMM, each of the circuits will measure approximately 6 V DC to ground. The audio being played is produced by a varying AC voltage that is centered around the DC bias voltage. The AC voltage causes the speaker cone to move and produce sound. |
| K132 Pedestrian Alert Sound Control Module | The control module K132 controls a speaker to emit an audible tone at low vehicle speeds to notify pedestrians of an approaching vehicle. |