LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (Power Seat System) >> Diagnostic Information and Procedures >> DTC B1735, B1740, B1745, B1750, B1755, B1760, B1815, or B1820 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector:S64D Seat Adjuster Switch - Driver
  3. Test for infinite resistance between the test points:Switch - All - Released
    • Component terminal A & E
    • Component terminal C & E
    • Component terminal D & E
    • Component terminal F & E
    • Component terminal G & E
    • Component terminal H & E
    • Component terminal J & E
    • Component terminal K & E
    • If less than infinite resistanceI 

      Replace the component:S64D Seat Adjuster Switch - Driver

    • Go to next step: If infinite resistance 
  4. Test for less than 2 ohms between the test points:Switch - Pressed
    • {Driver Seat Cushion Front Vertical Switch - Up}Component terminal A & E
    • {Driver Seat Cushion Front Vertical Switch - Down}Component terminal K & E
    • {Driver Seat Cushion Rear Vertical Switch - Up}Component terminal F & E
    • {Driver Seat Cushion Rear Vertical Switch - Down}Component terminal J & E
    • {Driver Seat Horizontal Switch - Forward}Component terminal D & E
    • {Driver Seat Horizontal Switch - Rearward}Component terminal C & E
    • {Driver Seat Back Switch - Forward}Component terminal H & E
    • {Driver Seat Back Switch - Rearward}Component terminal G & E
    • If 2 ohms or greater 

      Replace the component:S64D Seat Adjuster Switch - Driver

    • Go to next step: If less than 2 ohms 
  5. All OK.
scientia non olet · About LEMON Manuals