Circuit/System Verification
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Clear DTCs
- Verify no other DTCs are set.
- If any other DTCs are set
- Go to next step: If no other DTCs are set
- Verify DTC P0602 is not set.
- If DTC P0602 is set
- Program the control module:K17 Electronic Brake Control Module
- Verify DTC P0602 is not set.
- If set as a current DTC - Replace the component:K17 Electronic Brake Control Module
- Go to next step: If the DTC is not set
- All OK.
- Go to next step: If none of the DTCs are set
- Verify DTC P0601, P0603, P0604, P0606, P062F is not set.
- If any other DTCs are set
Replace the component:K17 Electronic Brake Control Module
- Go to next step: If none of the DTCs are set
- If any other DTCs are set
- All OK.