LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Antilock Brake System - Hybrid (Hp4)) >> Diagnostic Information and Procedures >> DTC C05B2 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify there are no DTCs set related to the following system/component:K43 Power Steering Control Module
    • Go to next step: If none of the DTCs are set 
  3. Verify the following component is properly installed:Steering Gear
    • Incorrect installation 

      Replace the component:Steering Gear

    • Go to next step: Correct 
  4. Perform the scan tool learn/reset function:Steering Wheel Angle Sensor Centering
  5. Verify that no DTCs are set.
    • If any DTC is set 
    1. Verify the following component is properly installed:Inflatable Restraint Sensing and Diagnostic Module
      • Incorrect installation - Replace the component:Inflatable Restraint Sensing and Diagnostic Module
      • Go to next step: Correct - Replace the component:K17 Electronic Brake Control Module
    • Go to next step: If the DTC is not set 
  6. All OK.
scientia non olet · About LEMON Manuals