Road Test: Notes
The following test provides a method of evaluating the condition of the automatic transmission. The test is structured so that most driving conditions would be achieved. The test is divided into the following parts:
- Electrical Function Check
- Garage Shifts
- Launch/Brake Sequence
- Reverse
- Steady State Cruising
- WOT Launch/Coast Downs
- Power-Downs/Lift Foots
If the vehicle you are testing is a Hybrid/Electric Vehicle and is equipped with an eAssist or BAS propulsion system, please refer to the applicable vehicle Owner Manual/Supplement for a complete description and an explanation of operating conditions for the automatic stop/start feature. When performing this Road Test, the auto stop/start must be verified to ensure the characteristics of this feature are operating as designed.
Before the road test, ensure the following:
- The engine is performing properly.
- Transmission fluid level is correct. Transmission Fluid Level and Condition Check
- Tire pressure is correct.
During the road test:
- Perform the test only when traffic conditions permit.
- Operate the vehicle in a controlled, safe manner.
- Observe all traffic regulations.
- View the scan tool data while conducting this test. Take along qualified help in order to operate the vehicle safely.
- Observe any unusual sounds or smells.
After the road test, check the following:
- Inspect for proper transmission fluid level. Transmission Fluid Level and Condition Check
- Inspect for any diagnostic trouble codes (DTCs) that may have set during the testing. Refer to the applicable DTC.
- Monitor the scan tool data for any abnormal readings or data.
- Inspect for fluid leaks. Fluid Leak Diagnosis