LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Automatic Transmission - VT40 (MRG) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0796 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the condition does not exist: Incorrect fluid level or condition - Transmission - Refer to:Transmission Fluid Level and Condition Check 
    • If a condition exists 

      Repair or replace as necessary.

    • Go to next step: If no condition exists 
  2. Ignition - On / Vehicle - In Service Mode
  3. Clear DTCs
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify DTC P0796 is not set.

    • If DTC P0796 is set 

      Refer to:Diagnostic Fault Information

    • Go to next step: If DTC P0796 is not set 
  5. All OK.
scientia non olet · About LEMON Manuals