Component Testing
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition/Vehicle - Off
- Remove the component:Control Valve Body Cover
- Disconnect the electrical connector:
- B12BA Transmission Fluid Pressure Sensor 1
- B12BB Transmission Fluid Pressure Sensor 2
- Test for infinite resistance between the test points:Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the appropriate component:B12B Transmission Fluid Pressure Sensor
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.