Fastener Specifications
WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| CV Boot Retaining Clamp |
| CV Joint Retainer Clip |
| Front Wheel Drive Intermediate Shaft Circlip |
| Front Wheel Drive Intermediate Shaft O-Ring |
| Front Wheel Drive Shaft Retaining Ring |
| Wheel Drive Shaft Washer |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Wheel Drive Shaft Nut | |
|
150 N.m (111 lb ft) |
|
Loosen 45 degrees |
|
250 N.m (185 lb ft) |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Intermediate Shaft Bracket Bolt | 58 N.m (43 lb ft) |