LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Rear Brake Hose Replacement >> Removal Procedure

Removal Procedure

WARNING:

Brake Dust Warning

WARNING:

Brake Fluid Irritant Warning

  1. Raise and support the vehicle. Lifting and Jacking the Vehicle
  2. Remove the tire and wheel assembly. Tire and Wheel Removal and Installation
  3. GM4235932

    Brake Pipe Fitting (1) - Disconnect

  4. Cap the brake pipe fitting to prevent brake fluid loss and contamination.
  5. GM4235933

    Brake Hose Retainer (1) - Remove

  6. GM4231232

    Brake Hose Fitting Bolt (1) - Remove

  7. GM4231237
    NOTE:

    Do NOT reuse the brake hose fitting gaskets.

    Brake Hose Fitting Gasket (1) @ Brake Hose Fitting (2) - Remove and DISCARD [2x]

  8. Plug the caliper inlet to prevent brake fluid loss and contamination.
  9. Remove the brake hose.
scientia non olet · About LEMON Manuals