LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Pressure Modulator Valve Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING:

Brake Fluid Irritant Warning

CAUTION:

Brake Fluid Effects on Paint and Electrical Components Caution

  1. Place the ignition switch in the OFF position.
  2. Without draining the coolant and without disconnecting the hoses, position aside the radiator surge tank. - Radiator Surge Tank Replacement (LTG)Radiator Surge Tank Replacement (LFV)
  3. GM4774223

    Clip (1) - Release

  4. GM4774225

    Clip (1) - Release

  5. GM4234155

    Master Cylinder Secondary Brake Pipe Fitting (1) - Disconnect

  6. Plug the master cylinder outlet port to prevent brake fluid loss and contamination.
  7. GM4234158

    Master Cylinder Primary Brake Pipe Fitting (1) - Disconnect

  8. Plug the master cylinder outlet port to prevent brake fluid loss and contamination.
  9. GM4213865

    Brake Pressure Modulator Valve Secondary Pipe Fitting (1) - Disconnect

  10. Plug the brake pressure modulator valve (BPMV) inlet port to prevent brake fluid loss and contamination.
  11. GM4213869

    Brake Pressure Modulator Valve Primary Pipe Fitting (1) - Disconnect

  12. Plug the BPMV inlet port to prevent brake fluid loss and contamination.
  13. Remove the brake pressure modulator valve pipe assembly.
scientia non olet · About LEMON Manuals