LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Malibu LS >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Hardware, Trim, And Upholstery >> Repair Instructions >> Front Seat Cushion Frame Replacement (Passenger Power)

Front Seat Cushion Frame Replacement (Passenger Power)

GM4546195Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
WARNING:

Refer to SIR Warning .

Preliminary Procedure Front Seat Cushion Cover and Pad Replacement 
1 Driver or Passenger Seat Back Frame Fastener [4x]
CAUTION:

Refer to Fastener Caution .

  1. Remove the seat back frame bolts.
  2. Prepare the bolts for installation as follows:
    1. Remove all traces of the adhesive patch from the bolts and the mating threads using the appropriate tools.
    2. Clean the threads of the bolts and mating threads with denatured alcohol or equivalent and allow to dry.
    3. Apply thread locking adhesive to the bolts. Adhesives, Fluids, Lubricants, and Sealers 
    4. Ensure there are no gaps in the thread locking adhesive once applied to the bolt.

Tighten 
45 N.m (33 lb ft)
2 Front Seat Adjuster Stop [2x]
NOTE:

The new cushion frame may not have adjuster stops installed. Transfer the adjuster stops from original frame or install new as needed. The frame may need to be adjusted to access the adjuster stops.
3 Driver or Passenger Seat Cushion Frame

Procedure

  1. Disconnect the electrical connector.
  2. Transfer components as necessary.
scientia non olet · About LEMON Manuals