Rear Bumper Valance Panel Replacement (Without GPN)

Fig 1: Rear Bumper Valance Panel Location (Without GPN)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Rear Bumper Fascia Replacement Rear Bumper Fascia Energy Absorber Replacement
1	Rear Bumper Valance Panel Bolt[2x] CAUTION: Refer to Fastener Caution . Tighten 2.5N.m (22 lb in)
2	Rear Bumper Valance Panel Clip [4x]
3	Rear Bumper Valance Panel Procedure Carefully push a small nylon wedge between the lower fascia and the rear bumper valance panel. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the upper fascia from the rear bumper valance panel. Transfer components as necessary.