Removal Procedure

Fig 1: Front Bumper Fascia Replacement
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia Upper Molding (2, 3) - Remove - Front Bumper Fascia Upper Molding Replacement
Remove the appropriate front wheelhouse liner bolts to gain access to the front bumper fascia bolt:
- For right side, refer to Front Wheelhouse Liner Replacement - Right Side
- For left side, refer to Front Wheelhouse Liner Replacement - Left Side
Courtesy of GENERAL MOTORS COMPANY

Front Compartment Air Deflector(4) - Remove - Front Compartment Air Deflector Replacement
Courtesy of GENERAL MOTORS COMPANY

Front Compartment Splash Shield(2) - Remove - Front Compartment Splash Shield Replacement
Front Bumper Fascia Bolt(2) - Remove[5x]
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia Bolt(1) - Remove[4x]
Courtesy of GENERAL MOTORS COMPANY

Carefully push a small nylon wedge between the fascia (1) and the fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia.
Courtesy of GENERAL MOTORS COMPANY

With the aid of an assistant, remove the fascia.(1)
Disconnect all electrical connectors.
Transfer components as necessary.