LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Impala Premier >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Power Brake Booster Vacuum Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Apply the brake pedal several times until the brake pedal becomes firm to deplete the power vacuum brake booster vacuum reserve.
  2. Disconnect the power brake booster vacuum sensor electrical connector.
  3. GM2607855

    Release the power brake booster vacuum rear pipe from the clips (1) on the vehicle front of dash.

  4. GM2607858

    Remove the power brake booster vacuum sensor (1) from the power vacuum brake booster.

  5. GM2607860

    Release the clamps and remove the power brake booster vacuum rear pipe hose (1) from the power brake booster vacuum sensor (2) and the power vacuum brake booster.

scientia non olet · About LEMON Manuals