LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Impala Premier >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Pressure Modulator Valve Secondary Pipe Replacement >> Installation Procedure

Installation Procedure

  1. Install the BPMV secondary brake pipe.
  2. GM2739673
    CAUTION:

    Refer to Fastener Caution .

    Connect the secondary brake pipe fitting (1) at the BPMV and tighten the fitting to 25 N.m (18 lb ft).

  3. GM2739671

    Connect the secondary brake pipe fitting (1) at the master cylinder and tighten the fitting to 25 N.m (18 lb ft).

  4. GM2738929

    Install the secondary brake pipe to the retaining clips (1).

  5. Connect the EBCM electrical connector.
  6. Reposition the radiator surge tank. Refer to Radiator Surge Tank Replacement (LFX) .
  7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure) .
  8. If equipped with RPO LFX, install the intake manifold cover. Refer to Intake Manifold Cover Replacement (LFX) .
scientia non olet · About LEMON Manuals