Circuit/System Testing

Ignition ON.
Verify that DTC C025E is not set.
- If the DTC is set
  Refer to DTC C025E .
- Go to next step: If the DTC is not set
Verify that the brake booster vacuum system has no damage, leakage or incorrect installation.
- If damage, leakage or incorrect installation is found
  Refer to Brake Assist System Diagnosis .
- Go to next step: If the inspection is OK
Test or replace the B19B Brake Booster Vacuum Sensor.
Verify the DTC does not set while operating the vehicle under the Conditions for Running the DTC.
- If the DTC sets
  Replace the K17 Electronic Brake Control Module.
- Go to next step: If the DTC does not set
All OK.