Rear Side Door Trim Replacement

Callout	Component Name
Preliminary Procedure Remove the rear side door accessory switch mount plate. Refer to Rear Side Door Accessory Switch Mount Plate Replacement .
1	Rear Side Door Inside Handle Bolt Cap NOTE: Use a suitable tool, place the tool between the notch located at the lower rear edge of the door handle cap and the door handle. Turn the suitable tool clockwise releasing the door handle cap, exposing the handle fastener.
2	Rear Side Door Inside Handle Fastener CAUTION: Refer to Fastener Caution .
3	Rear Side Door Pull Cup Liner
4	Rear Side Door Armrest Pull Cup Fastener (Qty: 2)
5	Rear Side Door Trim Assembly Procedure Use the appropriate plastic trim tool to aid in the removal of the door trim. Pull outward at the top to release the retainers, then lift up and off of the lock rod knob. Pull upwards on the door lock retainer cable to disengage. Disconnect the electrical connector.