LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Impala LT >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel And Console Trim >> Repair Instructions >> Instrument Panel Assembly Replacement >> Removal Procedure

Removal Procedure

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. GM2909784

    Remove the radio front speaker (2). Refer to Radio Front Speaker Replacement .

  3. GM2909782

    Remove the radio front center speaker (2). Refer to Radio Front Center Speaker Replacement .

  4. GM2897505

    Remove the instrument cluster (2). Refer to Instrument Cluster Replacement .

  5. GM2913584

    Remove the radio control (2). Refer to Radio Control Assembly Replacement .

  6. GM3286743

    Remove the bolts (1) securing the left side of the instrument panel to the instrument carrier.

  7. GM3286739

    Remove the bolts (1) securing the right side of the instrument panel.

  8. Remove the bolt (2) securing the inflatable restraint module to the instrument panel tie bar.
  9. GM2897497

    Remove the instrument panel compartment (3). Refer to Instrument Panel Compartment Replacement .

  10. GM2897494

    Remove the instrument panel knee bolster (3). Refer to Instrument Panel Knee Bolster Replacement .

  11. GM3018636

    Remove the steering column (2). Refer to Steering Column Replacement (N37)Steering Column Replacement (N38) .

  12. GM3286827

    Release the front floor console rear air duct retainer (1).

  13. Remove the instrument carrier bolts (2) and (3).
  14. GM3286838
    NOTE:

    Some of the electrical connections may be forward in the vehicle close to the tie bar and may not be readily visible or easily reached (example: HMI Module connector). Use special care disconnecting the instrument panel inflator module connector. Unclip the airbag connector from the radio bracket, disengage the CPA and separate the connector.

    With the aid of an assistant, remove the instrument panel and carrier (1) rearward and upward from the tie bar.

  15. Note the location and routing of the instrument panel wiring harness prior to removal to ensure proper installation. Proper installation of the instrument panel assembly will not be possible if the wiring is incorrectly routed.
  16. With the instrument panel and carrier pulled rearward, disconnect the instrument panel harness connectors and fasteners connecting the instrument panel assembly to the carrier.
  17. GM3286762

    With the aid of an assistant remove the instrument panel (1) from the instrument panel carrier.

scientia non olet · About LEMON Manuals