Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Rear Spring Bolt - Front Eye (Chassis Cab) | |
| First Pass: | 300 N.m (221 lb ft) |
| Final Pass: | 140 - 160 degrees |
| Rear Spring U-Bolt | Torque mating fastener |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Rear Shock Absorber Bolt - Lower | 150 N.m (111 lb ft) |
| Rear Shock Absorber Bolt - Upper | 25 N.m (18 lb ft) |
| Rear Spring Nut @ Frame | |
| First Pass: | 140 N.m (103 lb ft) |
| Final Pass: | 175 - 185 degrees |
| Rear Spring Nut @ Front Eye (Except Chassis Cab) | |
| First Pass: | 100 N.m (74 lb ft) |
| Final Pass: | 200 - 220 degrees |
| Rear Spring Nut @ Rear Eye | 160 N.m (118 lb ft) |
| Rear Spring U-Bolt Nut | |
| First Pass: | 140 N.m (103 lb ft) |
| Final Pass: | 175 - 185 degrees |
| Rear Stabilizer Shaft Insulator Clamp Bolt | 50 N.m (37 lb ft) |
| Rear Stabilizer Shaft Link Bolt | 70 N.m (52 lb ft) |
| Rear Stabilizer Shaft Link Nut | 65 N.m (48 lb ft) |