P16 Instrument Cluster: Scan Tool Information
Instrument Panel Cluster Scan Tool Data Parameters
| Parameter | System State | Expected Value | Description |
|---|---|---|---|
| Operating Conditions: Ignition ON | |||
| Battery Voltage | - | Varies | This displays volts. This is the voltage input supplied to the instrument panel cluster. |
| Brake Fluid | - | OK | The scan tool displays OK or Low. This is the state of the brake fluid level. |
| Brake Fluid Switch | - | Varies | This displays volts. This is the voltage status of the brake fluid switch. |
| Brake System Fault Detected | - | Varies | The scan tool displays OK if no brake system fault is detected. |
| DIC Fuel Info. | - | Inactive | The scan tool displays Active or Inactive. This is the state of the DIC Fuel Info. switch. |
| DIC Information Switch | - | Inactive | The scan tool displays Active or Inactive. This is the state of the DIC Information switch. |
| DIC Personalization | - | Off | The scan tool displays Active or Inactive. This is the state of the DIC Personalization switch. |
| Ignition 1 Input | - | Active | The scan tool displays Active or Inactive. This is the state of the Ignition 1 input to the instrument panel cluster. |
| Ignition Cycle Counter | - | Varies | The scan tool displays counts. This is the number of times the ignition has been cycled from the OFF to ON position. |
| Low Coolant Input | - | On | The scan tool displays Off and On. This is the status of the coolant level input. |
| Outside Air Temp. Filtered | - | Varies w/out side air temp. | The scan tool displays Fahrenheit or Celsius. This is the filtered outside air temperature as monitored by the IPC. |
| Outside Air Temp. Raw | - | Varies w/out side air temp. | The scan tool displays Fahrenheit or Celsius. This is the raw outside air temperature as monitored by the IPC. |
| Passenger Seatbelt Indicator Commanded | - | Off | This displays On or Off. This is the commanded state of the passenger seatbelt indicator. |
| Passenger Seatbelt Indicator Status | - | Off | This displays On or Off. This is the state of the passenger seatbelt indicator. |
| Set/Reset Switch | - | Inactive | The scan tool displays Active or Inactive. This is the state of the set/reset switch. |
Instrument Panel Cluster Scan Tool Output Controls
| Output Control | Description |
|---|---|
| Dimming | The IPC dims from 0-100 percent when you select INCREASE or DECREASE by 20 percent increments. |
| IPC Gauge Sweep Test | This output control is used to command the gauges in the instrument panel cluster from minimum to maximum when selected. |
| Lamp Test | The IPC illuminates the following indicators when you select On: ABS. Air Bag. Brake. CRUISE. Fasten safety belt. High beam. SECURITY. Upshift The indicators should illuminate until commanded Off. |