Transmission Case Front Cover and Drive Link Removal
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | Automatic Transmission Case Front Cover Bolt M6 x 30 [11x]
NOTE:
DISCARD the bolts. |
| 2 | Automatic Transmission Case Front Cover Procedure Use the GE-8433 puller bar and 2 bolts in the threaded holes of the front cover to remove it from the case. Special Tool GE-8433 Puller Bar Equivalent regional tools:Special Tools |
| 3 | Automatic Transmission Case Front Cover Seal
NOTE:
DISCARD the seal. |
| 4 | Drive Sprocket Thrust Washer- Front |
| 5 | Drive Sprocket |
| 6 | Drive Link |
| 7 | Drive Sprocket Thrust Washer- Rear |
| 8 | Automatic Transmission Front Support Cover Gasket
NOTE:
Remove and DISCARD the gasket. |