Stator Shaft Support Assemble

WARNING: This page is about a different variant/trim than selected.

Special Tools

DT-50912 Seal Installer

Equivalent regional tools:Special Tools

Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Do not use old seal rings. Install NEW seal rings. Reusing old seal rings may cause internal transmission leaks and transmission damage.

CAUTION:
Size the fluid seal rings for at least 5 minutes after installation to obtain proper seal ring size. Failure to do so may cause internal transmission leaks and transmission damage.

NOTE:
Use the large taper side of DT-50912-1 seal sizer for initial seal sizing, then flip the tool over for final sizing.

Torque Converter Fluid Seal (1) - Install NEW

NOTE:

Ensure fluid seal ring is installed properly as shown.

1-3-5-6-7 Clutch Fluid Seal Ring (2) - Install NEW [2x]