LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Engine Controls And Fuel - 2.8L (LWN) Diesel - Diagnostic Information And Procedures (1 Of 3)) >> Diagnostic Information and Procedures >> DTC P040B-P040E or P041B-P041E >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    It may take up to 2 min for all vehicle systems to power down before an accurate ground or low reference circuit continuity test can be performed.

  1. Ignition/Vehicle & All vehicle systems - Off
  2. Disconnect the appropriate electrical connector : B130 Exhaust Gas Recirculation Temperature Sensor
  3. Test for less than 10 ohms between the test points : Low Reference circuit terminal 1 & Ground
    • If 10 ohms or greater 
    1. Disconnect the electrical connector : K20 Engine Control Module
    2. Test for less than 2 ohms between the test points :
      • {Sensor 1}Low Reference circuit terminal 1 @ Component harness & Terminal 19 X3 @ Control module harness
      • {Sensor 2}Low Reference circuit terminal 1 @ Component harness & Terminal 10 X3 @ Control module harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Replace the component : K20 Engine Control Module
    • Go to next step : If less than 10 ohms 
  4. Ignition - On / Vehicle - In Service Mode
  5. Test for 4.8 to 5.2 V between the test points : EGR Cooler Temperature Sensor 1, 2Signal circuit terminal 2 & Ground
    • If less than 4.8 V 
    1. Ignition/Vehicle - Off
    2. Disconnect the electrical connector : K20 Engine Control Module
    3. Test for less than 2 ohms between the test points :
      • {Sensor 1}Signal circuit terminal 2 @ Component harness & Terminal 20 X3 @ Control module harness
      • {Sensor 2}Signal circuit terminal 2 @ Component harness & Terminal 24 X3 @ Control module harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • Go to next step : If less than 2 ohms
    4. Test for infinite resistance between the test points : Signal circuit terminal 2 @ Component harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • If infinite resistance - Replace the component : K20 Engine Control Module
    • If greater than 5.2 V 
    1. Test for less than 1 V between the test points : Signal circuit terminal 2 @ Component harness & Ground
      • If 1 V or greater - Repair the short to voltage on the circuit.
      • If less than 1 V - Replace the component : K20 Engine Control Module
    • Go to next step : If between 4.8 and 5.2 V 
  6. Replace the appropriate component : B130 Exhaust Gas Recirculation Temperature Sensor
  7. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  8. Verify the DTC does not set.
    • If the DTC sets 

      Replace the component : K20 Engine Control Module

    • Go to next step : If the DTC is not set 
  9. All OK.
scientia non olet · About LEMON Manuals