Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Perform the scan tool control function : Wait to Start Indicator - On and Off
Verify the scan tool parameter :
- Wait to Start Indicator Control Circuit High Voltage Test Status = Not Run or OK
- Wait to Start Indicator Control Circuit Low Voltage Test Status = Not Run or OK
- Wait to Start Indicator Control Circuit Open Test Status = Not Run or OK
- If not the specified state
Refer to : Circuit/System Testing
- Go to next step : If the specified state
- Perform the scan tool control function : Wait to Start Indicator - On and Off
Verify the component turns On and Off : Wait to Start Indicator @ P16 Instrument Cluster
- If the component does not turn On and Off
Refer to : Circuit/System Testing
- Go to next step : If the component turns On and Off
- If the component does not turn On and Off
- Perform the scan tool control function : Wait to Start Indicator - On
Verify a condition does not exist with the component : Wait to Start Indicator @ P16 Instrument Cluster - Turns Off
- Perform the action while monitoring the component : Wiggle the harness and connector : X @ K20 Engine Control Module
- If a condition exists
Repair as necessary - Wiring / Terminal(s) / Electrical Connector(s)
- Go to next step : If no condition exists
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify that no DTCs are set.
- If the DTC sets
Refer to : Circuit/System Testing
- Go to next step : If the DTC does not set
- If the DTC sets
- All OK.