Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P0335 Condition 1

Crankshaft Position Sensor = No Signal - For greater than 4 s

Condition 2

Crankshaft Position Sensor = No Signal - For greater than 0.3 s

Condition 3

Crankshaft Position Sensor = No Signal - During 2 engine revolution(s)

P0336 Condition 1

Crankshaft Position Sensor = Signal synchronization lost 10 times within 10 s.

Condition 2

Crankshaft Position Sensor = Sync gap not detected - For greater than 0.4 s

Condition 3

Crankshaft Position Sensor = Sync gap not detected - Since last starter engagement - For greater than 1.5 s

Condition 4

Crankshaft Position Sensor = Less than 1 pulse(s) or Greater than 65, 000 pulses - During 1 engine revolution(s) - For 8 out of 10 engine revolutions

Frequency the DTC runs = Continuously - After the running conditions are met