Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Disconnect the appropriate electrical connector : Q17 Fuel Injector
- Test for 0.2 to 1.5 ohms between the test points : Control terminal 1 & Control terminal 2
- If not between 0.2 and 1.5 ohms
Replace the component : Q17 Fuel Injector
- Go to next step : If between 0.2 and 1.5 ohms
- If not between 0.2 and 1.5 ohms
- Test for infinite resistance between the test points : Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component : Q17 Fuel Injector
- Go to next step : If infinite resistance
- If less than infinite resistance
- All OK.
NOTE:
The specified resistances are valid for components at room temperature.