Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P1248 - P124F is not set and no other DTCs are set.
- If DTC P1248 - P124B is not set and other DTCs are set
Refer to : Circuit/System Testing - Test 1
- If DTC P1248 - P124B is set and other DTCs are set
Refer to : Circuit/System Testing - Test 2
- If DTC P1248 - P124B is set and no other DTCs are set
Refer to : Circuit/System Testing - Test 3
- Go to next step : If no DTC is set
- If DTC P1248 - P124B is not set and other DTCs are set
- Engine - Running
- Verify the scan tool parameter : Cylinder 1 - 4 Current Misfire Counter = Does not Increment
Perform the action while monitoring the parameter :
Wiggle the harness and connector : K20 Engine Control Module
- If the parameter value increments
Repair as necessary - Wiring / Terminal(s) / Electrical Connector(s)
- Go to next step : If the parameter value does not increment
- If the parameter value increments
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Repeat step 2
- Go to next step : If the DTC is not set
- If the DTC sets
- All OK.
NOTE:
This step only applies to the following component DTCs : Q17 Fuel Injector