Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify no other DTCs are set.
- If any other DTCs are set
Refer to : Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step : If no other DTCs are set
- If any other DTCs are set
- Verify the condition does not exist :
- Fuel Type - Incorrect
- Fuel - Contaminated/Poor Quality
- If a condition exists
Refer to : Fuel System Specifications , / Contaminants-in-Fuel Diagnosis
- Go to next step : If no condition exists
- Inspect for aftermarket devices which may affect the operation of the system.
- If a condition exists
Repair or replace as necessary
- Go to next step : If no condition exists
- If a condition exists
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to : Circuit/System Testing
- Go to next step : If the DTC is not set
- If the DTC sets
- All OK.
NOTE:
Time to set this DTC may take several drive cycles