LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Engine Controls And Fuel - 2.8L (LWN) Diesel - Diagnostic Information And Procedures (1 Of 3)) >> Diagnostic Information and Procedures >> DTC P0101-P0103 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    Circuit/System Testing must be performed before proceeding with Component Testing.

  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector : B75C Multifunction Intake Air Sensor
  3. Install the special tool : EL-38522 Variable Signal Generator
    • Red lead @ Signal circuit terminal 6
    • Black lead @ Ground
    • Set the voltage to 5 V
    • Set the frequency to 5 000 Hz
    • Set the duty cycle to 50%
  4. Engine at Idle
  5. Verify the scan tool parameter : MAF Sensor = 4 950 to 5 050 Hz
    • If not between 4 950 and 5 050 Hz 

      Replace the component : K20 Engine Control Module

    1. Ignition/Vehicle - Off
    2. Disconnect the appropriate electrical connector : K20 Engine Control Module
    3. Test for less than 2 ohms between the test points : Signal circuit terminal 6 @ Component harness & The other end of the circuit @ Control module harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Replace the component : K20 Engine Control Module
    • Go to next step : If between 4 950 and 5 050 Hz 
  6. Replace the component : B75C Multifunction Intake Air Sensor
scientia non olet · About LEMON Manuals