Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P1474, P1475, P1476, P1477, P1478
- DTC P16D7, P16D8, P16D9, P24D0, U02A3 = Not set
- Ignition On
- Ignition Voltage = Greater than 11 V
- Reductant Control Module Relay = ON
Frequency the DTC runs = Continuously - After the running conditions are met
P1479, P147B
- DTC P142C, P142D, P142E, P142F, P1474, P1475, P1476, P1477, P1478, P16D7, P16D8, P16D9, P24B0, P24B1, P24B3, P24B5, P24B6, P24D0, U02A3 = Not set
- Ignition On
- Ignition Voltage = Greater than 11 V
- Particulate Matter Sensor = 200 to 425°C (392 to 797°F)
- Reductant Control Module Relay = ON
Frequency the DTC runs = Continuously - After the running conditions are met
P1488
- DTC U02A3 = Not set
- Verify there are no DTCs set related to the following component/system :
- B66 Intake Air Temperature Sensor
- B75C Multifunction Intake Air Sensor
- Q14 Exhaust Gas Recirculation Valve
- Q17 Fuel Injector
- Ignition On
- Ignition/Vehicle - Off - For greater than 8 h
- Ignition Voltage = Greater than 11 V
- Particulate Matter Sensor = 0 to 300°C (32 to 572°F)
- Reductant Control Module Relay = ON
Frequency the DTC runs = Continuously - After the running conditions are met