Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P142B, P142C, P142D, P142E, P142F, P1435, P1436 is not set.
- If any of the DTCs are set
Refer to : Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step : If none of the DTCs are set
- If any of the DTCs are set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify DTC P1474, P1475, P1475, P1476, P1477, P1478, P1479, P147B, P1488 is not set.
- If any of the DTCs are set
Replace the component : B136 Exhaust Particulate Matter Sensor
- Go to next step : If none of the DTCs are set
- If any of the DTCs are set
- All OK.