Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P1474, P1475, P1476, P1477, P1478, P16D7, P16D8, P16D9, P24B0, P24B1, P24B3, P24B5, P24B6, P24D0, U02A3 is not set.
- If any DTC is set
Refer to : Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step : If no DTC is set
- If any DTC is set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify DTC P142B, P142C, P142D, P142E, P142F, P1435, P1436 is not set.
- If any of the DTCs are set
Replace the component : B136 Exhaust Particulate Matter Sensor
- Go to next step : If none of the DTCs are set
- If any of the DTCs are set
- All OK.