Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P0403, P0405, P0406, P1402, P1407, P140F, P1424 is not set.
- If DTC P0403, P0405, P0406, P1402, P1407, P140F, P1424 is set
Refer to : Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step : If DTC P0403, P0405, P0406, P1402, P1407, P140F, P1424 is not set
- If DTC P0403, P0405, P0406, P1402, P1407, P140F, P1424 is set
- Verify the condition does not exist :
- Air Cleaner Element - Saturated with water/Restricted
- Exhaust System - Leaking/Missing components/Restricted - Refer to : Symptoms - Engine Exhaust
- Intake Manifold - Leaking
- Intake Air Duct - Loose Clamps/Cracked/Visible Damage
- Mass Airflow Sensor - Contamination of the measuring element/Water intrusion
- If a condition exists
Repair or replace as necessary
- Go to next step : If no condition exists
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Replace the component : Q14 Exhaust Gas Recirculation Valve
- Go to next step : If the DTC does not set
- If the DTC sets
- All OK.