Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P11B3
- DTC U029D, U029E = Not set
- Verify there are no DTCs set related to the following component/system :
- B66 Intake Air Temperature Sensor
- B75C Multifunction Intake Air Sensor
- B195 Nitrogen Oxides Sensor - Circuit
- Q14 Exhaust Gas Recirculation Valve
- Q17 Fuel Injector
- Engine = Running
- Ignition Voltage = Greater than 11 V
- NOx Sensor 2 Heater Mode = Allowed
Frequency the DTC runs = Continuously - After the running conditions are met
P22B6
- DTC P119D-P119F, P11BE, P11BF, P11C0, P11C7, P11C8, P11D0-P11D2, P11D8, P11D9, P11DA, P11DC, P11DE, P11FC-P11FE, P220B, P229E, P22A3-P22A9, U029E = Not set
- Engine = Running
- Ignition Voltage = Greater than 11 V
- NOx Sensor 2 Heater Mode = Allowed
Frequency the DTC runs = Continuously - After the running conditions are met
P22B7
- Verify there are no DTCs set related to the following component/system :
- B66 Intake Air Temperature Sensor
- B75C Multifunction Intake Air Sensor
- B195 Nitrogen Oxides Sensor - Circuit
- Q14 Exhaust Gas Recirculation Valve
- Q17 Fuel Injector
- Engine = Running
- Ignition Voltage = Greater than 11 V
- NOx Sensor 2 Heater Mode = Allowed
Frequency the DTC runs = Continuously - After the running conditions are met
P2A01
- DTC U029D, U029E = Not set
- Verify there are no DTCs set related to the following component/system :
- B66 Intake Air Temperature Sensor
- B75C Multifunction Intake Air Sensor
- B195 Nitrogen Oxides Sensor - Circuit
- Q14 Exhaust Gas Recirculation Valve
- Q17 Fuel Injector
- Fuel System
- Engine Speed = 1, 500 to 3, 500 RPM
- Ignition Voltage = Greater than 11 V
- NOx Sensor 1, 2 Heater Mode = Allowed
Frequency the DTC runs = Continuously - After the running conditions are met