LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Engine Controls And Fuel - 2.8L (LWN) Diesel - Diagnostic Information And Procedures (2 Of 3)) >> Diagnostic Information and Procedures >> DTC P10D6-P10D8 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    If you were sent here from DTC P026A, refer to Circuit System Testing.

  1. Engine idling.
  2. Verify the scan tool Charge Air Cooler Outlet Temperature Sensor parameter is between-39 to +198°C (-38 to +388°F).
    • If not between -39 to +198°C (-38 to +388°F) 

      Refer to Circuit System Testing.

    • Go to next step : If between -39 to +198°C (-38 to +388°F) 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • Go to next step : If the DTC does not set 
  5. All OK.
scientia non olet · About LEMON Manuals