Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
For an overview of the component/system, refer to : Exhaust Aftertreatment System Description
| Circuit | Description |
|---|---|
| Control - Terminal 2 | The output circuit is switched to 12 V to activate the component. |
| Control - Terminal 1 | The output circuit is switched to ground to activate the component. |
| Component | Description |
|---|---|
| Q61 Reductant Injector | The reductant injector is used to dose and atomize the reductant into the exhaust system. |
| K115 Reductant Control Module | The control module controls the heating and dosing of the reductant. |