Component Testing
WARNING: This page is about a different variant/trim than selected.
Static Test
- Ignition/Vehicle - Off
- Disconnect the electrical connector : E52 Reductant Line Heater
- Test for 2 to 4 ohms between the test points : Control circuit terminal 1 & Control circuit terminal 2
- If not between 2 and 4 ohms
Replace the component : E52 Reductant Line Heater
- Go to next step : If between 2 and 4 ohms
- If not between 2 and 4 ohms
- Test for infinite resistance between the test points : Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component : E52 Reductant Line Heater
- Go to next step : If infinite resistance
- If less than infinite resistance
- All OK.