Component Testing
WARNING: This page is about a different variant/trim than selected.
Static Test
- Ignition/Vehicle - Off
- Disconnect the electrical connector : A38 Reductant Pump and Sensor Assembly
- Test for 1 to 2 ohms between the test points : Control terminal 9 & Low Reference terminal 11
- If not between 1 and 2 ohms
Replace the component : A38 Reductant Pump and Sensor Assembly
- Go to next step : If between 1 and 2 ohms
- If not between 1 and 2 ohms
- Test for infinite resistance between the test points : Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component : A38 Reductant Pump and Sensor Assembly
- Go to next step : If infinite resistance
- If less than infinite resistance
- All OK.