LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Express 2500 LS, 6.0L Eng VIN G >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Engine Controls And Fuel - 2.8L (LWN) Diesel - Diagnostic Information And Procedures (2 Of 3)) >> Diagnostic Information and Procedures >> DTC P1051, P20B9, P20BA-P20BC, P248A, or P248B >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On / Vehicle - In Service Mode
  2. Perform the scan tool control function : Reductant Heater 1 - On

    Verify the scan tool parameter : Reductant Heater 1 Current = 5 to 10 A

    • If not the specified value 

      Refer to : Circuit/System Testing

    • Go to next step : If the specified value 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to : Circuit/System Testing

    • Go to next step : If the DTC is not set 
  4. All OK.
scientia non olet · About LEMON Manuals